Table of Contents
Advertisement
2.
BEFORE YOU START USING THE UNIT
Please read the separate safety instruction booklet provided before you commence welding.
NOTE!
Pay particular attention to the risks associated with fire and explosion.
2.1
Unpacking
Always before using the equipment, make sure it was not damaged during transportation.
Also check that you have received what you ordered and that instructions are included.
The packaging material of the products is suitable for recycling.
Transportation
The machine should be transported in an upright position.
Always move the welding machine by lifting it from the handle. Never pull it from the
NOTE!
welding cable or other cables.
Environment
The machine is suitable for both indoor and outdoor use, but it should be protected from rain
and sunshine. Store the machine in a dry and clean environment and protect it from sand and
EN
dust during use and storage. The recommended operating temperature range is –20...+40 °C.
Place the machine in such a way that it does not come in contact with hot surfaces, sparks and
spatters. Make sure the air flow in the machine is unrestricted.
2.2
Positioning and location of the machine
Place the machine on a firm, dry and level surface. Where possible, do not allow dust or other
impurities to enter the machines cooling air flow. Preferably site the machine above floor level.
Notes for positioning the machine
• The surface inclination should not exceed 15 degrees.
• Ensure the free circulation of the cooling air. There must be at least 20 cm of free space
around the machine for cooling air to circulate.
• Protect the machine against heavy rain and direct sunshine.
Do not operate the machine in rain. The protection class of the machine is IP23S, which
NOTE!
allows for outside preserving and storage only.
Never use a wet welding machine.
NOTE!
Never aim metallic grinding spray or sparks towards the equipment.
NOTE!
2.3
Distribution network
All regular electrical devices without special circuits generate harmonic currents into
distribution network. High rates of harmonic current may cause losses and disturbance to
some equipment.
Minarc Evo 180 comply with IEC 61000-3-12.
2.4
Serial number
The serial number of the unit is marked on the rating plate. The serial number makes it
possible to trace product manufacturing series. You might need the serial number when
placing spare parts orders or when planning maintenance.
4
Minarc Evo 180
Advertisement
Table of Contents
