Table of Contents
Advertisement
TitraLab
®
Calibration
delay elapsed
Calibration
parameters
Calibration
request
Calibration
results
parameters
Calibration
sequence
This message appears at titration start. A new electrode or reagent
calibration is required. The delay Periodicity entered in the Edit elec-
trode or Edit reagent screen has elapsed,
169.
Press ✓ and perform a calibration.
For an electrode calibration method,
parameters", page
112.
For a reagent calibration method,
ters", page
191.
Available if Electrode type =
• pH single, pH combined (w/o temperature sensor),
• ISE single, ISE combined (w/o temperature sensor),
• Conductivity (w/o temperature sensor).
Select the option Calibrate request = Yes to calibrate
electrodes.
The corresponding calibration parameters and standards will be
displayed.
Enter in:
Edit electrode menu
Refer to "Results menu", page
To run an electrode calibration sequence,
(SAC sequence)", page
To run a reagent calibration sequence,
sequence)", page
190.
To prepare an electrode calibration stack,
stack", page
113.
To prepare a reagent calibration stack,
page
192.
TitraLab 870 Reference Manual
see "Periodicity", page
see "Electrode calibration
see "Reagent calibration parame-
210.
see "Electrode calibration
111.
see "Reagent calibration (SAC
see "Electrode calibration
see "Reagent calibration stack",
Page 73
Advertisement
Table of Contents
