Table of Contents
Advertisement
TitraLab
®
Beakers: [F;L]
Beep
Blank (Yes/No)
Blank
concentration
Blank not
required
Blank on
inflection no.
The beakers information is displayed in the Edit sequence menu of a
sequence.
It indicates the First and Last positions occupied by the beakers in the
sequence.
If Yes has been selected, three beeps will sound when a result is
obtained.
Enter in:
Setup menu > Configuration
Select Yes to subtract the volume of reagent used to titrate the solvent
from the volume found for the dissolved or diluted sample.
When you run for the first time a method with a blank, you start with
the determination of the blank. The blank volume is saved with the
method. If you start again this method, you have the choice between
running an analysis with the blank alone or running an analysis of the
sample with subtraction of the blank volume to the result.
Enter in:
Edit method menu
Refer to "Direct ISE measurement method - definition", page
This message appears at the start of a sequence, if a method
sequence programmed with a blank titration has now been repro-
grammed without a blank.
Go to Sequence/Sample stack, Edit sequence menu and remove the
blank titration method from the sequence.
Inflection point number (1 to Number of IP) on which the blank volume
will be subtracted.
Enter in:
Edit method > Results (for Monotonic IP, Dynamic IP or Continuous IP
method).
TitraLab 870 Reference Manual
95.
Page 67
Advertisement
Table of Contents
