Table of Contents
Advertisement
TitraLab
®
Flush burette
Format
(printouts)
A flush rinses the burette, tubings and delivery tip thoroughly. It is
recommended to flush the burette on a daily basis.
The Titration Manager carries out a flush after each installation or rea-
gent replacement procedure.
To run a flush:
1. Enter the Burette functions menu.
2. Select the burette in the Address field.
3. Press 3 Flush.
The flush procedure runs as follows:
• Empty,
• Fill 4 ml (*) then empty (5 times).
(*) 1 ml for a 10 ml burette and 10 ml for a 50 ml burette.
The length of the "Flush" procedure depends on the volume of the
burette.
You can also flush simultaneously all installed burettes,
"Global flush burettes", page
Format = Listing
The whole report is printed in one operation.
Format = Page by page
The printer waits until a preset number of lines have been collected
then prints one page (this number is set by the Nb line per
page parameter),
see "Nb lines per page (printouts)", page
The printing format applies for automatic printouts (at the end
of a test) or manual printouts (by pressing key Print).
Access:
Setup Menu > Configuration
Refer to "Printouts", page
TitraLab 870 Reference Manual
133.
177.
see
161.
Page 131
Advertisement
Table of Contents
