Table of Contents
Advertisement
TitraLab
®
Acceptation
Access routine
mode
Active electrode
unknown in
"method ID"
Result acceptance time limit.
When the time entered for the Acceptation has elapsed the
measurement will be accepted whether stable or not.
For the signal to be accepted once the Acceptation has
elapsed, the Max. Stab. time must be greater than the
Acceptation time.
Enter in:
Edit method > Parameters menu
Edit reagent > Calibration parameters menu
Edit electrode > Calibration parameters menu
Range available:
0 to 59:59 min:s
Press Stop for 3 seconds from the Main window then press 2.
These rules can be set by the Supervisor to allow the routine user
access to certain operations.
Enter in:
Setup menu > Access routine mode
The method in use, has at least one electrode which has not been
defined. Press ✓ and declare the electrode in the Electrode ID field of
the Method parameters screen.
The reagent in use, uses an electrode which has not been defined for
the reagent calibration. Press ✓ and declare the electrode in the
Parameters screen of the reagent calibration, Electrode - ID field.
TitraLab 870 Reference Manual
Page 45
Advertisement
Table of Contents
