Error Messages - Radiometer Analytical TitraLab 870 Reference Manual

TitraLab ®

Error messages

Page 128
See also "Check command", page
Titration Manager errors:
"Active electrode unknown in "method ID"": see page 45.
"Add. reagent = Titrant": see page 47.
"Archives data lost - Cal. Data lost - Methods kept": see page 52.
"Back reagent = Titrant": see page 56.
"Back reagent unknown": see page 56.
"Blank not required": see page 67.
"Blank required": see page 68.
"Calibration delay elapsed": see page 73.
"Curves data lost - Cal. Data kept - Methods kept": see page 89.
"Dilution or sample unit incompatible": see page 94.
"Electrode calibration not required": see page 112.
"Electrode not calibrated": see page 117.
"Electrodes are different": see page 119.
"Expiry date elapsed": see page 130.
"Ground conflict": see page 136.
"Input address conflict": see page 138.
"Insufficient number of beakers in sequence": see page 140.
"Max. stab reached": see page 148.
"Max. vol - Predose > Bur. vol": see page 149.
"Max. volume reached": see page 149.
"Measure type conflict for a reprocessing in "Method ID"": see page 150.
"Method type incompatible for a reprocessing": see page 154.
"Method wrong type": see page 154.
"Missing EP": see page 159.
"Missing IP": see page 159.
"No curve generation for a reprocessing": see page 161.
"No curve stored within the instrument": see page 161.
"QC analysis required": see page 182.
"QC not required": see page 183.
"QC periodicity elapsed": see page 183.
"Reagent calibration not required": see page 191.
"Reagent not calibrated": see page 194.
"Reagent titre not entered": see page 195.
"Ref. electrode conflict": see page 197.
"Reset memory": see page 204.
"Same buffer change buffer": see page 220.
"Sample dilution conflict": see page 223.
"Sample unit conflict": see page 226.
"Sample type incompatible": see page 225.
"Standard unit incompatible": see page 238.
"Std conc. too low (or high)": see page 240.
"The sequence is empty": see page 248.
"Wrong buffer": see page 254.
SAC errors:
"Communication failure (SAC error)": see page 79.
"ERR#32 (SAC error)": see page 127.
"Missing beaker (SAC error)": see page 159.
"No stirrer (SAC error)": see page 162.
"SAC arm obstructed (SAC error)": see page 219.
"SAC option missing (SAC error)": see page 219.
"SAC switch Off/On (SAC error)": see page 219.
"Tray missing (SAC error)": see page 249.
"Turntable blocked (SAC error)": see page 251.
"Wrong type (SAC error)": see page 254.
TitraLab 870 Reference Manual
78.