Replace Burette; Replace Electrodes - Radiometer Analytical TitraLab 870 Reference Manual

TitraLab ®

Replace burette

Replace
electrodes
Page 198
Before replacing, rinse the burette to remove the reagent.
1. Enter the Burette functions menu.
2. Select the burette to be replaced at the Address line,
"Address", page
3. Press 5 Replace burette. The piston is moved to its lowest posi-
tion (filling operation).
4. The data of the burette to be replaced are displayed. Check and
press 1.
5. Enter the new burette volume and serial number as for a burette
installation. Press 1 to confirm.
6. Remove the burette and press ✓.
7. Install the new burette at the displayed address and press ✓ ,
"Install burette", page
Use this procedure to replace an electrode with another one of the
same type and ID.
Proceed as follows:
1. Select the method/sequence using the electrode.
2. Press 2 in the Electrode window.
3. Press 3 Replace electrode.
4. Select the electrode to be replaced. The ID list contains all the
electrodes connected.
5. Disconnect electrode and press ✓ to confirm.
6. Connect the new electrode at the address indicated.
7. Enter the serial number and confirm.
TitraLab 870 Reference Manual
50.
139.
see
see