Ref. Electrode Conflict; Reference Temp; Reject A Result; Remove Burette - Radiometer Analytical TitraLab 870 Reference Manual

TitraLab ®
Ref. electrode
conflict
Reference
Temp.

Reject a result

Remove burette

Remove method
from a
sequence

Remove reagent

Two reference electrodes are being used in the same beaker.
Change one of the reference electrodes in the electrode system.
Refer to "Temp. correction None/Linear/Nat. water", page
Refer to "Result accepted (Yes/No)", page
Before removing, rinse the burette to remove the reagent.
1. Enter the Burette functions menu:
2. Press 6 Remove burette. The piston is moved to its lowest
position (filling operation).
3. Check the burette data and press 1.
4. Remove the burette and press ✓,
1. Select the sequence to be emptied,
227.
2. Press 2 Sequence/Sample stack then 3 Edit sequence.
3. Select the method to be removed using the LEFT/RIGHT arrow
keys.
4. Press 3 Delete.
5. Press 1 Remove method then ✓ to confirm or press Esc to leave
the screen without removing the method.
The method is removed from the sequence but is not deleted.
To remove all the methods from a sequence,
quence", page
Use this procedure when you no longer wish to use the reagent. To
remove a reagent, run the rinse procedure in the Burette functions
menu.
Refer to "Burette functions menu", page
TitraLab 870 Reference Manual
205.
see "Install burette", page
see "Select sequence", page
119.
68.
246.
139.
see "Empty se-
Page 197