P05 Group--Input Terminals - INVT Goodrive3000 Series Operation Manual

Goodrive3000 series medium voltage VFD
Function
code
P03.39–
P03.40
P05 group––Input terminals
Function
code
P05.01
The function code is used to select input terminal polarity.
When a bit is 0, the input terminal is positive; when a bit is 1, the input terminal is negative.
BIT3
S4
Function
code
P05.03 Digital input filter time
The function code is used to set the filter time for S1–S4. In strong interference cases, increase the value to avoid
maloperation.
Function
code
P05.04
P05.05
P05.06
P05.07
Terminal input is described as follows:
Setting
0
1
2
Name
the function code. The changes on
the feedback angle will effect the
current waveform. It is not
recommended to modify this
parameter. The feedback angle is
set properly by default.
(Valid only for the six-pulse rectifier)
Reserved
Name
Digital input terminal
polarity
BIT2
S3
Name
Name Description
0: No function
Function of S1
1: Run
terminal
2: Reset faults
Function of S2
3: External fault
terminal
4: Reserved
Function of S3
5: Enable
terminal
6–12: Reserved
13: Clear accumulative electricity
consumption
Function of S4
14: Keep accumulative electricity
terminal
consumption
15: Reserved
Function
The PWM rectifier does not act even if with signal input. Set unused
No function
terminals to "no function" to avoid misaction.
Run External terminals are used to control PWM rectifier running.
External fault reset function, same as the reset function of the
Fault reset STOP/RST key on the keypad. You can use this function to reset
faults remotely.
Description
Description
0x0–0xF
BIT1
S2
Description
0.000–1.000s
Description
-28-
Goodrive3000 rectifier
Setting range Default
Setting range Default
0x0–0xF 0x0
BIT0
S1
Setting range Default
0.000–1.000 0.000s
Setting range Default
1
2
0
0–15
0