INVT Goodrive3000 Series Operation Manual page 96

Goodrive3000 series medium voltage VFD
The following table lists the function code options. A same output terminal function can be repeatedly selected.
Setting
0
1
2
3 Running reversely
4
5
Frequency level detection
6
Frequency level detection
7
8 Frequency reached
9 Running at zero speed
Upper limit frequency
10
Lower limit frequency
11
12
13
14 Overload pre-alarm
15 Underload pre-alarm
16
completed (Reserved)
17
completed (Reserved)
18
19
20 External fault is valid
21
22 Running time reached
MODBUS communication
23
virtual terminal output
POROFIBUS/CANopen
24 communication virtual
Ethernet communication
25
virtual terminal output
Function
Invalid The output terminal does not have any function.
Running Output is valid when there is frequency output during running.
Output is valid when there is frequency output during forward
Running forward
running.
Output is valid when there is frequency output during reverse
running.
Jogging Output is valid when there is frequency output during jogging.
VFD fault Output is valid when VFD fault occurred.
Refer to the descriptions for P08.32–P08.33.
FDT1
Refer to the descriptions for P08.34–P08.35.
FDT2
Refer to the description for P08.36.
Output is valid when the VFD output frequency and reference
frequency are both zero.
Output is valid when the running frequency reaches upper limit
reached frequency.
Output is valid when the running frequency reached lower limit
reached frequency.
Main circuit and control circuit powers are established, the
Ready for running protection functions do not act; when the VFD is ready to run,
output is valid.
Pre-exciting Output is valid during pre-exciting of the VFD.
Output is valid after the pre-alarm detection time elapsed based on
the overload pre-alarm threshold. For details, see the descriptions
for P11.08–P11.10.
Output is valid after the pre-alarm detection time elapsed based on
the underload pre-alarm threshold. For details, see the
descriptions for P11.11–P11.12.
Simple PLC stage When the present state of the simple PLC is completed, output is
valid.
Simple PLC cycle When a single cycle of the simple PLC is completed, output is
valid.
Reserved
Reserved
Output is valid when the external fault (EF) occurs.
Reserved
The output is valid after the accumulated running time of the VFD
exceeds the time set in P08.27.
Output corresponding signals based on the set value of MODBUS.
Output ON signal when it is set to 1, and output OFF signal when it
is set to 0.
Output corresponding signal based on the set value of
PROFIBUS/CANopen; output ON signal when it is set to 1, output
terminal output OFF signal when it is set to 0
A signal is output based on the value set through Ethernet
communication. When the value is 1, the ON signal is output; when
Description
-90-
Goodrive3000 inverter