INVT Goodrive3000 Series Operation Manual page 73

Goodrive3000 series medium voltage VFD
Function
code
FWD/REV running
P01.13
FWD/REV running
P01.14
The function code is used to set the shifting mode between forward running and reverse running.
This function code indicates the transition time specified in P01.13 during FWD/REV rotation switching. See the following
figure:
Function
code
P01.15
Stop speed detection
P01.16
P01.17
The function code is used to set the stop speed detection mode.
0: Detect by the speed setting (without speed delay). This is the only detection method in V/F mode.
1: Detect by speed feedback (valid only for vector control)
In vector control or P01.16=0, when the ramp reference frequency is less than or equal to the set value of P01.15 and
passes delay time of stop speed P01.24, the VFD will coast to stop immediately.
In vector control or P01.16=1, when the actual frequency is less than or equal to the set value of P01.15, the VFD will
coast to stop immediately; when the frequency is larger than the set value, the VFD will stop after the delay time of
P01.17.
Function
code
Terminal-based running
P01.18 command protection at
When the channel of running commands is terminal control, the system detects the state of the running terminal during
power-on.
Name
0.0–3600.0s
deadzone time
0: Switch at zero frequency
1: Switch at the starting frequency
switching mode 2: Switch after the speed reaches the
stop speed with a delay
Start delay
Braking time
time
before start
Run
command
Name
Stop speed 0.00–100.00Hz
0: Detect by the speed setting (without
speed delay)
mode 1: Detect by speed feedback (valid only
for vector control)
Feedback speed
0.0–100.00 s (valid when P01.16=1)
detection time
Name
0: The terminal running command
is invalid at power-on
1: The terminal running command
power-on
is valid at power-on
Description
Constant
Acceleration
speed
ON
Description
Description
-67-
Goodrive3000 inverter
Setting range
0.0–3600.0
0–2
Time t
Decele- DC braking
time for stop
ration
Wait time before DC
braking for stop
OFF
Setting range
0.00–100.0
0–1
0.0–100.0
Setting range
0–1
Default
0.0s
0
Default
0.50Hz
0
0.5s
Default
0