Figure 24: Mounting Positions - WAGO I/O System 750 Manual

82 Mounting
•
Vertical bottom mounting position

Figure 24: Mounting Positions

Use an end stop in the case of vertical installation!
When mounting in the "vertical top" or "vertical bottom" mounting position, also
mount an end stop below the fieldbus node to protect the fieldbus node against
sliding.
WAGO item no. 249-116
WAGO item no. 249-117
WAGO item no. 249-197
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
End stop for DIN 35 rail, 6 mm wide
End stop for DIN 35 rail, 10 mm wide
End stop for DIN 35 rail, 14 mm wide, reinforced
WAGO I/O System 750