Table 99: Wbm "Configuration Of Network Services" Page - "Http" Group; Table 100: Wbm "Configuration Of Network Services" Page - "Https" Group; Table 101: Wbm "Configuration Of Network Services" Page - "I/O-Check" Group - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
"HTTP" Group
Table 99: WBM "Configuration of Network Services" Page – "HTTP" Group
Parameter
Service active
Click the [Submit] button to apply a change. The change takes effect
immediately.
Disconnection abort on disabling
If the HTTP service is disabled, the connection to the product may be interrupted.
In that case, reopen the page.
"HTTPS" Group
Table 100: WBM "Configuration of Network Services" Page – "HTTPS" Group
Parameter
Service active
"I/O-CHECK" Group
This group appears if the controller supports WAGO-I/O-CHECK.
Table 101: WBM "Configuration of Network Services" Page – "I/O-CHECK" Group
Parameter
Service active
Click the [Submit] button to apply a change. The change takes effect
immediately.
Explanation
Enable/disable the HTTP service.
This service is disabled by default.
Explanation
State of HTTPS service is displayed here.
Explanation
Enable/disable the WAGO-I/O-CHECK-Service.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 199
Manual