WAGO I/O System 750 Manual page 118

118 Commissioning
Parameters and passwords are overwritten!
Parameters and passwords for the Linux
overwritten by a controller reset.
Stored boot projects are deleted, including existing web visualizations.
Subsequently installed firmware functions are not overwritten.
Software licenses are retained.
The inactive system is not changed by the reset.
If you have any questions, contact WAGO Support.
The controller is restarted after the controller reset.
Proceed as follows to reset the controller:
1. Press the Reset button (RST).
Set the mode selector switch to the "RESET" position.
2.
Press and hold both buttons until the "SYS" LED alternately flashes
3.
red/green after approx. 8 seconds.
When the "SYS" LED flashes red/green alternately, release the mode
4.
selector switch and Reset button.
Do not interrupt the reset process!
If you release the Reset button (RST) too early, then the controller restarts
without performing the controller reset.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
®
and WBM users of the controller are