Power Jumper Contacts; Figure 7: Power Jumper Contacts; Table 7: Legend For Figure "Power Jumper Contacts - WAGO I/O System 750 Manual

32 Properties
4.1.4.2

Power Jumper Contacts

The controller 750-8210/040-000 is equipped with 2 self-cleaning power contacts
for transferring of the field-side power supply to down-circuit I/O modules. These
contacts are designed as spring contacts.

Figure 7: Power Jumper Contacts

Table 7: Legend for Figure "Power Jumper Contacts"

Contact
1
2
Risk of injury due to sharp-edged blade contacts!
The blade contacts are sharp-edged. Handle the I/O module carefully to prevent
injury. Do not touch the blade contacts.
Do not exceed maximum values via power contacts!
The maximum current that can flow through the power jumper contacts is 10 A.
The power jumper contacts can be damaged and the permissible operating
temperature can be exceeded by higher current values.
When configuring the system, do not exceed the permissible maximum current
value. If there is a higher power requirement, you must use an additional supply
module to provide the field voltage.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
Type
Spring contact
Spring contact
WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
Function
Potential feed-in (Uv) for field supply
Potential feed-in (0 V) for field supply