Create Bootable Image" Page; Table 89: Wbm "Create Bootable Image" Page - "Create Bootable Image From - WAGO I/O System 750 Manual

190 Appendix

15.2.1.2.8 "Create Bootable Image" Page

You can create a bootable image on the "Create Bootable Image" page.
"Create bootable image from boot device" Group
Once the destination has been determined and output, it is then checked and the
results of this check are displayed below the settings:
Table 89: WBM "Create Bootable Image" Page – "Create bootable image from active partition" Group
Parameters
Boot Device
Destination
- Free space on target device:
If the available memory space is less than 5% a warning is displayed. You
can still start the copy process despite the warning. If the available space is
too low, a corresponding message is displayed and copying cannot be
started.
- Device being used by CODESYS:
If the device is being used by CODESYS, a warning is displayed. Although
it is not recommended, you can still start the copying procedure despite this
warning.
Click [Start Copy] to start the copying procedure. If the outcome of the test is
positive, copying begins immediately. If errors have been detected, a
corresponding message is displayed and copying is not started. If warnings have
been issued, these are displayed again and you must then confirm that you still
wish to continue.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
Meaning
The medium from which the boot was made is
displayed.
Depending on which medium has been booted, the
following destination is available for selection after
boot-up for the image to be generated:
System was booted
from
Memory Card
Internal memory
WAGO I/O System 750
Target partition for
"bootable image"
 Internal Flash
 Memory Card