Configuration Of Mac Address Filter" Page; Table 134: Wbm "Configuration Of Mac Address Filter" Page - "Global Mac - WAGO I/O System 750 Manual

230 Appendix

15.2.1.4.4 "Configuration of MAC Address Filter" Page

The "Configuration of MAC address filter" page displays the firewall configuration
on the ETHERNET level.
The "MAC Address Filter Whitelist" contains two default entries with the following
values:
Description:
MAC address:
MAC mask:
Description.
MAC address:
MAC mask:
If you enable the first default entry, this already allows communication between
different WAGO devices in the network.
Enable the MAC address filter before activation!
Before activating the MAC address filter, you must enter and activate your own
MAC address in the "MAC Address Filter Whitelist."
Otherwise you cannot access the device via the ETHERNET. This also applies to
other services that are used by your device, e.g., the IP configuration via DHCP.
If the "MAC Address Filter Whitelist" does not contain the MAC address of your
DHCP server, your device will lose its IP settings after the next refresh cycle and
is then no longer accessible.
If the "MAC Address Filter Whitelist" does not contain an entry, the activation of
the filter is prevented.
If at least one enabled address is entered, you will receive an appropriate
warning before activation, which you have to acknowledge.
The check described above is only performed in the WBM but not in the CBM!
"Global MAC address filter state" Group
Table 134: WBM "Configuration of MAC Address Filter" Page – "Global MAC address filter state"
Group
Parameters
Filter enabled
Click the [Submit] button to apply the change. The change takes effect
immediately.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
All WAGO devices
00:30:DE:00:00:00
ff:ff:ff:00:00:00
Enable docker bridges
02:42:00:00:00:00
ff:ff:00:00:00:00
Explanation
Enable or disable the global MAC address filter.
WAGO I/O System 750