WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
6.3.2
WAGO DIN Rail
WAGO carrier rails meet the electrical and mechanical requirements shown in the
table below.
Table 40: WAGO DIN Rail
Order number
210-112 /-113
210-197 /-114
210-118
210-198
210-196
For vibration loads > 4g, observe the following installation instructions:
•
Use pan-head screws or blind rivets at least every 60 mm (12 mm pin
spacing) to secure the DIN rail.
•
Make the open conductor length between strain relief and wire connection
as short as possible.
•
Use the reinforced end stop 249-197.
Description
35 × 7.5;
1 mm; steel blue chromated; slotted/unslotted
35 × 15; 1.5 mm; steel blue chromated; slotted/unslotted
35 × 15; 2.3 mm; steel blue chromated; unslotted
35 × 15; 2.3 mm; copper; unslotted
35 × 8.2; 1.6 mm; aluminum; unslotted
Version 1.7.0, valid from FW Version 04.01.10(23)
Mounting
85
Manual