WAGO I/O System 750 Manual page 194

194 Appendix
File size must not exceed the size of the internal drive!
Note that the amount of data in the media/sd/copy/ directory must not exceed the
total size of the internal drive.
Restoration only possible from internal memory!
If the device was booted from the memory card, the firmware cannot be restored.
Reset by restore
A reset is performed when the system or settings are restored by CODESYS!
Connection loss through restore
If the restore changes the parameters of the ETHERNET connection, the WBM
may then no longer be able to open a connection to the device. You must call the
WBM again by entering the correct IP address of the device in the address line.
Note the restore time!
The restore process takes approx. 2 ... 3 minutes.
After the restore process, the controller is restarted and is then ready for use
again.
Click the [Restore] button to start the restore operation.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR