WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
15.2.1.2.11 "Active System" Page
The settings for specifying the partition from which the system is started are
shown on the "Active System" page.
"Boot Device" Group
Table 92: WBM "Active System" Page – "Boot Device" Group
Parameter
Boot Device
"System <n> (Internal Flash)" Groups
Table 93: WBM "Active System" Page – "System <n> (Internal Flash)" Group
Parameter
Active
Configured
State
Click the respective [Activate] button to start the required system at the next
reboot.
Provide a bootable system!
A functional firmware backup must be available on the boot system!
Explanation
The storage medium from which the device was
booted is displayed here.
Explanation
This shows whether the system is active.
This shows whether the system should be active
after the next reboot.
The system status is displayed here.
good
The system is valid and can be used.
The system is not valid and cannot be
bad
used.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 195
Manual