Wbm User Configuration" Page; Table 120: Wbm "Wbm User Configuration" Page - "Change Password" Group - WAGO I/O System 750 Manual

218 Appendix

15.2.1.2.26 "WBM User Configuration" Page

The settings for user administration are displayed on the "WBM User
Configuration" page.
"Change Password" Group
Changing Passwords
The initial passwords as delivered are documented in this manual and therefore
do not provide sufficient protection. Change the passwords to meet your
particular needs!
Table 120: WBM "WBM User Configuration" Page – "Change Password" Group
Parameter
Old Password
New Password
Confirm Password
Click the [Submit] button to apply a change. The change takes effect
immediately.
Note the permitted characters for WBM passwords!
If passwords with invalid characters are set for the WBM outside the WBM (e.g.,
from a USB keyboard), access to the pages directly on the display is no longer
possible because only permitted characters are available from the virtual
keyboard.
General Rights of WBM Users
The WBM users "admin" and "user" have rights beyond the WBM to configure the
system and install software.
User administration for controller applications is configured and managed
separately.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
Explanation
Enter the current password here for authentication.
Enter the new password here.
Permitted characters for the password are the
following ASCII characters: a ... z, A ... Z, 0 ... 9,
blank spaces and special characters:
! ? % + = ( ) _ # " - / ` < > * ; , : .
Enter the new password again here for confirmation.
WAGO I/O System 750