Advanced Intrusion Detection Environment (Aide)" Page; Table 142: Wbm "Advanced Intrusion Detection Environment (Aide)" Page - "Run Aide Check At Startup" Group; Table 143: Wbm "Advanced Intrusion Detection Environment (Aide)" Page - "Control Aide And Show Log" Group - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR

15.2.1.4.9 "Advanced Intrusion Detection Environment (AIDE)" Page

The network security settings are available on the "Advanced Intrusion Detection
Environment (AIDE)" page.
"Run AIDE check at startup" Group
Table 142: WBM "Advanced Intrusion Detection Environment (AIDE)" Page – "Run AIDE check at
startup" Group
Parameter
Service active
Click the [Submit] button to apply the changes. The changes only take effect
when the controller restarts.
"Refresh Options" group
Table 143: WBM "Advanced Intrusion Detection Environment (AIDE)" Page – "Control AIDE and
show log" Group
Parameter
Select Action
Read only the last n
Automatic refresh interval
(sec)
Click [Refresh] to update the display. The button is only displayed if the cyclic
refresh is not enabled.
To enable cyclic refresh, click the [Start] button. The button is only displayed if
cyclic refresh is enabled and has not yet started.
To stop cyclic refresh again, click the [Stop] button. The button only appears if
cyclic refresh is enabled.
The cyclical refresh is performed for as long as the "Advanced Intrusion
Detection Environment (AIDE)" page is open. If you change the WBM page, the
Explanation
Here, you can activate/deactivate the "AIDE check"
when the controller is started.
Explanation
Select here the action to be executed.
readlog The log data are displayed.
The database is initialized and filled with
init
the current values.
The current values are compared against
check
the values stored in the database.
The current values are compared with the
update values stored in the database and the
database then updated.
Activate display of only the last n messages. You
also specify the number of messages to be
displayed.
Select the checkbox to enable cyclic refresh.
Enter the cycle time in seconds in which a cyclic
refresh is performed. The label of the button
("Refresh"/"Start"/"Stop") changes depending on
status.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 237
Manual