WAGO I/O System 750 Manual page 77

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
The boot project is loaded automatically and the settings automatically activated
after a restart. The "Home directory on memory card enabled" setting determines
whether the boot project of the internal drive or the memory card is loaded. This
setting can be called up on the WBM page "PLC Runtime Configuration" in the
"Configuration" tab, selection "PLC Runtime".
File size must not exceed the size of the internal drive!
Note that the amount of data in the media/sd/copy/ directory must not exceed the
total size of the internal drive.
Restoration only possible from internal memory!
If the device was booted from the memory card, the firmware cannot be restored.
Reset by restore
A reset is performed when the system or settings are restored by CODESYS!
Connection loss through restore
If the restore changes the parameters of the ETHERNET connection, the WBM
may then no longer be able to open a connection to the device. You must call the
WBM again by entering the correct IP address of the device in the address line.
Note the restore time!
The restore process takes approx. 2 ... 3 minutes.
After the restore process, the controller is restarted and is then ready for use
again.
Version 1.7.0, valid from FW Version 04.01.10(23)
Functions 77
Manual