Table 65: Wbm "Plc Runtime Configuration" Page - "Webserver Configuration - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100
"Webserver Configuration" Group
Table 65: WBM "PLC Runtime Configuration" Page – "Webserver Configuration" Group
Parameter
CODESYS V2 Webserver
State
e!RUNTIME Webserver
State
Default Webserver
Click [Submit] to apply the change. The change takes effect immediately.
In its default setting, the WBM is called up when only entering the IP address.
To update the display after switching, enter the IP address again in the address
line of the Web browser.
To display the web visualization, the Webserver must be enabled (in WBM under
"Ports and Services" -> "PLC Runtime Services") and there must be a suitably
configured application.
Regardless of the default Webserver setting, the WBM can be called up at any
time with "https://<IP address>/wbm" and the Web visualization with "https://<IP
address>/webvisu".
Possible error messages when calling up the web visualization
The "500 − Internal Server Error" message indicates that the Webserver is not
enabled.
A page with the header "WebVisu not available" means that no application has
been loaded in the product using web visualization.
Meaning
This displays the status (enabled/disabled) of the
CODESYS V2 Webserver.
This field only appears if the controller supports the
CODESYS V2 runtime system.
This indicates the status (enabled/disabled) of the
e!RUNTIME Webserver.
This field only appears if the controller supports the
e!RUNTIME runtime system.
Choose here whether the Web-based Management
or web visualization of the runtime system should be
displayed when only entering the IP address of the
controller.
Web-Based The Web-based Management is
Management displayed.
WebVisu The web visualization of the runtime
system is displayed.
Version 1.1.0, valid from FW Version 03.08.07(20)
Appendix 135
Manual