GE Vivid S5 N Service Manual page 765

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
d.) Plug the USB connector into the previously-vacated USB port on the Vivid S5/S6 chassis as
4.) Plug the mini USB connector into the DVD/CD port located at the rear of the DVD/CD drive as
shown in
5.) Re-fit the DVD cover making sure it is seated correctly - then secure the DVD cover in position and
tighten the two Phillips screws ((refer to
6.) Return and fasten the two Phillips screws previously removed from either side of the securing panel
(refer to
position.
7.) Return the bottom rear cover, as described in the
page
8.) Return the Vivid S5 N or Vivid S6 N front cover, as described in the
Procedure" on page
9.) Return the Vivid S5 N or Vivid S6 N left and right side covers, as described in the
Installation Procedure" on page 8-7
10.)Proceed to perform the following functionality tests:
-
-
11.)Insert a CD-R disk in the DVD /CD-RW Drive. Then eject and remove the CD-R disk to check the
eject mechanism functions properly.
2
EVISION
shown in Figure 8-273.
Figure 8-273 USB Connector Plugged into the USB Port
Figure 8-274.
Figure 8-274 Mini USB Connector Plugged into DVD/CD
Figure 8-269 on page
8-23.
8-19.
"Grounding Continuity" on page 10-23
"Chassis Current Leakage Test" on page 10-24
Chapter 8 - Replacement Procedures
Figure 8-25 on page
8-236). Make sure the DVD /CD-RW Drive is firmly secured in
"Bottom Rear Cover Installation Procedure" on
and "Right Side Cover Installation Procedure" on page
VS5 N VS6 N
S
AND ERVICE
The second USB port on the left.
Plug the USB connector into the
J14B port
8-24)).
"Front Cover Installation
"Left Side Cover
M
ANUAL
8-5.
8-239