GE Vivid S5 N Service Manual page 584

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
8-3-8-4 Rear Handle Installation Procedure
8-3-8-4-1 Installing Handles Glued in Position
NOTE: Identify the left and right rear handle before starting this procedure.
1.) Apply the RTV 102 silicone sealant to a few points along the aluminium bar.
2.) Slide the left handle onto the aluminium bar pushing it until it meets the aluminium T-joint.
3.) Repeat
4.) Allow the glue to dry overnight.
5.) Next morning, check that the handles are properly secured.
8-3-8-4-2 Installing Handles Secured with Mounting Screws
1.) Identify the left and right handle before starting the procedure.
Left handle
Mounting screw
Figure 8-72 Exploded View Showing Rear Handles - (New-type System)
2.) Slide the left handle onto the aluminium support bar and then secure it by replacing the mounting
screw (previously removed).
3.) Repeat
8-58 Section 8-3 - Control Console Components Replacement Procedures
2
EVISION
step 1 and step 2 to install the right handle.
step 2 to install the right handle.
VS5 N VS6 N
S
AND
ERVICE
Right handle
Mounting screw
M
ANUAL