GE Vivid S5 N Service Manual page 649

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
8-6-4 Hard Disk Replacement Procedure
4) Working from the side of the cage, use a small Phillips screwdriver to loosen and remove the screw
from the metal securing plate that holds the Hard Disk in position (as shown in
5) Using a finger and thumb, grip the metal plate firmly and pull to the left to slide the Hard Disk straight
out of the cage assembly - see
8-6-4-5 Hard Disk Installation Procedure
NOTE: When replacing the BEP or Hard Disk, one must either obtain new access codes that will fit the
system ID which is programmed on the BEP, or program the BEP system ID to fit the access codes
2
EVISION
Figure 8-152 Loosening the Screw from the Metal Securing Plate
Figure 8-153 Removing the Hard Disk
Chapter 8 - Replacement Procedures
(cont'd)
Screw
Figure 8-153 below.
VS5 N VS6 N
S
AND ERVICE
Figure 8-152
Metal Securing Plate
(attached to Hard Disk)
Screw
Screwdriver
Hard Disk
Metal Securing Plate
M
ANUAL
below).
8-123