GE Vivid S5 N Service Manual page 292

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
4-3-1-5 Light Detector Test for Vivid S6 N only
Table 4-9
Step
1
2
3
4
4-3-1-6 Monitor Test
This procedure is performed in stages, in the order shown in the table below. First, verify the monitor
settings and then proceed with the tests that follow.
Table 4-10
Step
1
2
3
4
5
6
7
8
1
2
3
4
4-22
2
EVISION
Light Detector Test
Task
Boot-up the System in Regular Scanning Mode.
Press LCD (F4 Key) to start the LCD adjustment.
Rotate the Brightness, Contrast and Blue Tint to max
values.
Select AutoAdjust on the softkey menu.
Monitor Test
Task
VERIFY MONITOR SETTINGS
Boot-up the System in Regular Scanning Mode
Press Config
Under the Connectivity tab, select TCPIP
Select Advanced
In the address bar, type Control panel and
press Enter
From the Control Panel, select Display then
select Settings
From the Settings Tab, select Advanced.
Select Intel® Extreme Graphics2 for mobile
> Graphics Properties > Video Overlay.
When done, press OK to close all windows.
LCD PIXEL TEST:
Boot-up the System in Maintenance Mode
Press Alt +Config to start the diagnostic
package
From the Diagnostic Test Tree, select Back
End.
This will activate PC Doctor diagnostics.
Run the System Diagnostics\Monitor Test.
Section 4-3 - Functional Checks
VS5 N
Expected Result(s)
LCD adjustment will change; the status bar for each of
the three parameters will move to the max position.
The Screen will change Brightness, Contrast and Tint
parameters to in accordance with the environmental
lighting.
Expected Result(s)
Make sure resolution is set to 800 x 600 pixels, 16 bit.
If not, select the correct resolution settings.
Make sure the settings are:
• Gamma = 0
• Contrast = 50
• Saturation = 50
• Brightness = 7
• Contrast = 1
VS6 N
S M
AND
ERVICE ANUAL