GE Vivid S5 N Service Manual page 149

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
3-5-4 Connecting the ECG
NOTE: The ECG may be connected to the system at any time, whether the system is powered ON or OFF.
Do not use the Vivid 7 ECG cable with the Vivid S5 N or Vivid S6 N system.
NOTICE
• To connect the internal ECG, carefully push the end of the cable connector into the ECG connector
port (the green, rectangular-shaped socket located on the right side of the front of the system -
beside the pencil probe connector), as shown in
The same connector is used both for external and internal ECG. The appropriate ECG cable kit should
be ordered when external ECG is to be used.
The ECG cable is a modular cable comprising four different cable parts. The main part (trunk) is a single
cable connecting to the unit at one end, with a cable splitter device at the other end. The splitter has five
receptacles, only three of which are used with the Vivid S5 N or Vivid S6 N ultrasound unit.
Three color-coded electrode cables are inserted into the splitter in the appropriate color-coded
receptacles. Each electrode cable hooks up to the appropriate stick-on electrode by a clip-type
connector. The color coding of the electrodes follows one of two standards that are common in different
parts of the world. The cable splitter has a drawing defining the color codes, names and electrode
placements for each of the three cables, as shown in
2
EVISION
Figure 3-85 Location of ECG Connector Port
Chapter 3 - System Setup
VS5 N
AND
Figure 3-85 below.
Figure 3-86 on page 3-74.
VS6 N
S M
ERVICE ANUAL
3-73