GE Vivid S5 N Service Manual page 664

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
8-6-5 BEP Replacement Procedure
8-6-5-5 BEP Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the appropriate
movie clips previously referenced in the
1) Carefully return the new BEP to the correct position in the cage assembly - refer to
page
NOTE: IMPORTANT - When replacing the BEP or Hard Disk, one must either obtain new access codes
that will fit the system ID which is programmed on the BEP, or program the BEP system ID to
fit the access codes already registered in the Hard Disk. Only qualified personnel should
perform these tasks.
2) Check that the BEP is seated correctly then return and fasten the three screws (previously
removed) to secure the BEP to the cage assembly - refer to
3) Proceed to reconnect the following cables to their connectors on the BEP (refer to
a.) Reconnect the Fan-to-BEP power cable
b.) Reconnect the RFI-to-BEP Flex cable.
c.) Reconnect the DC/DC-to-BEP power cable.
d.) Reconnect the USB cable
4) Carefully reconnect the Keyboard cable to the BEP; return and tighten the screw on the bracket to
hold the cable connector in place - see
seated so that it is flush with the top of the bracket (push down if necessary, taking care not to
damage the wires inside the cable).
5.) Secure the cables with a plastic cable tie wrap, as indicated in
6.) Return the battery, battery bracket and cable, as described in the
Procedure
7.) Return the hard disk, as described in the
8) Return the cabinet cage assembly to the system, reconnect the cables (previously disconnected),
close the cabinet cage door and fasten securely with the two latches.
Refer to the
9) Return the front cover, as described in the
19.
e.) Return the left and right side covers, as described in the
10.)Turn ON the system and boot-up.
8-138
2
EVISION
8-137.
and 8-6-3-5 "Battery Bracket Installation Procedure" on page
8-6-1-4 "Cabinet Cage Assembly Closing and Installation Procedure" on page
Procedure" on page 8-7
Section 8-6 - Lower Section Components Replacement Procedures
(cont'd)
8-6-5-4 "BEP Removal Procedure" on page
Figure 8-166. Make sure that the Ground cable is properly
8-6-4-5 "Hard Disk Installation Procedure" on page
8-2-6-4 "Front Cover Installation Procedure" on page 8-
and 8-2-2-4 "Right Side Cover Installation Procedure" on page
VS5 N VS6 N
S
AND
8-135.
Figure 8-169 on
Figure 8-168 on page 8-136.
Figure
Figure 8-165 on page
8-6-2-5 - Battery Installation
8-121.
8-2-3-4 "Left Side Cover Installation
M
ERVICE ANUAL
8-167):
8-135.
8-123.
8-114.
8-5.