GE Vivid S5 N Service Manual page 736

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
8-8-2 Preparation
Modifying BIOS Settings prior to Software Installation
NOTE: This preparation procedure is required to enable system reboot from the USB Flash Drive containing
the system software.
1.) Enter the BIOS setup
(by performing system shutdown and restart, then pressing F2 when the computer starts).
2.) In the BIOS screen, click the Boot tab.
3.) Under Boot priority order, change the order so that USB HDD is second in the list.
NOTE: If USB HDD is in the Excluded menu (as shown below), move it to the Boot priority order list by selecting
USB HDD and pressing the x keyboard key.
With USB HDD now listed in Boot priority order (as shown below), promote it to the second position in
the list by selecting it, then pressing and holding <Shift>, repeatedly pressing the + button until it is in
the number 2 position (i.e. after USB CDROM, as shown in
8-210
2
EVISION
(cont'd)
Figure 8-261 Boot Priority Order - USB HDD Second
Section 8-8 - Software Loading
VS5 N VS6 N
AND
Figure 8-261).
S M
ERVICE ANUAL