GE Vivid S5 N Service Manual page 551

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
8-2-11 DVD Cover Replacement Procedure
6.) Pull out and remove the DVD cover.
8-2-11-4 DVD Cover Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the movie clip
previously referenced in the
1) Make sure the control console is raised to its maximum height.
2) Return the DVD cover to the correct position on the system, carefully aligning the top of the cover
with the screw holes on the top of the peripheral cage.
3.) Working from the top of the peripheral cage, fasten the two screws (previously loosened) and
tighten securely to fasten the DVD cover in position - see
4) Install the front cover, as described in
5) Install the right rear cover, as described in the
6) Install the left and right side covers, as described in
page 8-7
7.) Proceed to perform the following functionality tests:
-
-
2
EVISION
Figure 8-26 DVD Cover Removed
DVD Cover Removal
and the "Right Side Cover Installation Procedure" on page
"Grounding Continuity" on page 10-23
"Chassis Current Leakage Test" on page 10-24
Chapter 8 - Replacement Procedures
(cont'd)
Procedure.
Figure
"Front Cover Installation Procedure" on page
"Right Rear Cover Installation Procedure" on page 8-12
"Left Side Cover Installation Procedure" on
VS5 N VS6 N
S
AND ERVICE
8-25.
8-19.
8-5.
M
ANUAL
8-25