GE Vivid S5 N Service Manual page 549

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
8-2-10 Bottom Rear Cover Replacement Procedures
8-2-10-1 Tools
None.
8-2-10-2 Preparations
Shut down the Vivid S5 N or Vivid S6 N ultrasound unit, as described in
page 4-7.
8-2-10-3 Bottom Rear Cover Removal Procedure
NOTE: The bottom rear cover is secured to the base of the main assembly frame by five ball and snap-
lock securing clips on the inner side of the cover - two at the top and three at the bottom - as
illustrated below.
1) Working from the rear of the system, pull the lower portion of the cover away from the system main
assembly frame to release it from the lower snap-lock securing clips (see
2) Pull the upper portion of the cover away from the system main assembly frame to release it from
the upper snap-lock securing clips (see
3.) Remove the cover.
Securing Clips
8-2-10-4 Bottom Rear Cover Installation Procedure
1) Return the bottom rear cover to its original position at the rear of the system.
2) Align the top of the cover with the two upper securing clips and push it until it clicks into position.
3) Align the bottom of the cover with the three lower securing clips and push it until it clicks into
position.
4.) Proceed to perform the following functionality tests:
-
-
2
EVISION
Figure 8-24 Position of Bottom Rear Cover Securing Clips
"Grounding Continuity" on page 10-23
"Chassis Current Leakage Test" on page 10-24
Chapter 8 - Replacement Procedures
VS5 N
Figure 8-24).
VS6 N
S M
AND ERVICE
4-2-3 "Power Shut Down" on
Figure 8-24).
Bottom Rear Cover
ANUAL
8-23