GE Vivid S5 N Service Manual page 613

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
4.) Unscrew the 10 Torx retaining screws and remove them from the LED and Soft Menu Board - those
visible in
5.) Disconnect the two flat cables (indicated with arrows in
6.) Lift up and remove the LED and Soft Menu Board.
8-4-10-4 LEDs and Soft Menu Board Installation Procedure (New-type Operator Panel)
1.) Carefully place the replacement LED and Soft Menu Board into the operating panel, positioning it
correctly on the plastic retaining holders. Press the Board gently into its home position.
2.) Return and fasten the 10 Torx screws (previously removed) to secure the board firmly in place.
3.) Reconnect the two flat cables (previously disconnected).
4.) Refit the Keyboard Bottom Cover, and secure it with the screws previously removed - as described
in the
5.) Re-fit the Keyboard Assembly, as described in the
page
6.) Proceed to perform the following functionality tests:
-
-
-
-
-
-
-
2
EVISION
Figure 8-101 are encircled.
Figure 8-101 LED and Soft Menu Board
"Keyboard Bottom Cover Removal Procedure" on page
8-39.
"Alphanumeric Keyboard Test" on page 4-18
"Extended Keyboard and Trackball Test" on page 4-18
"Speakers Tests" on page 4-21
"Light Detector Test for Vivid S6 N only" on page 4-22
"USB Test" on page 4-37
"Grounding Continuity" on page 10-23
"Chassis Current Leakage Test" on page 10-24
Chapter 8 - Replacement Procedures
VS5 N
AND
Figure 8-101).
8-59.
"Keyboard Assembly Removal Procedure" on
VS6 N
S M
ERVICE ANUAL
8-87