GE Vivid S5 N Service Manual page 536

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
8-2-4 Right Rear Cover Replacement Procedures
8-2-4-1 Tools
Use the appropriate Phillips-type screwdrivers, as indicated in the right rear cover replacement
procedures.
8-2-4-2 Preparations
Shut down the Vivid S5 N or Vivid S6 N ultrasound unit, as described in
page 4-7.
8-2-4-3 Right Rear Cover Removal Procedure
1) Disconnect any peripherals currently connected to the system.
2) Remove the front cover, as described in
3) Remove the right side cover, as described in
4) If necessary, remove the Basket (as described in the
and/or the Tray (as described in the
NOTE: The right rear cover is secured to the base of the main assembly frame by two screws: one at
the top of the cover; one through a securing tab on the inner right side of the cover, as illustrated
below.
Right Rear Cover
5) Loosen and remove the screw from the top bracket of the cover (see
6.) Loosen and remove the screw from the securing tab on the inner right side of the cover
(see
8-10
2
EVISION
Figure 8-10 Position of Right Rear Cover and Securing Screw
Figure 8-10 and Figure
Section 8-2 - Cover Replacement Procedures
"Front Cover Removal Procedure" on page
"Right Side Cover Removal Procedure" on page
"Tray Removal Procedure" on page
Screw
8-11).
VS5 N VS6 N
AND
4-2-3 "Power Shut Down" on
"Basket Removal Procedure" on page
8-22), as applicable.
Screw
(through securing tab)
Figure
S M
ERVICE ANUAL
8-17.
8-5.
8-20)
8-11).