GE Vivid S5 N Service Manual page 647

Hide thumbs Also See for Vivid S5 N:

P R E L I M I N A R Y

Battery Bracket Installation Procedure

When performing the following installation procedure steps, it may be helpful to review the appropriate

movie clips previously referenced in the

1.) Working with the battery bracket upside down on the table surface (and close to the system),

reconnect the battery cable (attached to the battery bracket) to the BEP (see

2.) Carefully lift the battery bracket back and turning it over, swing into position on the cage assembly

3.) Slide the bracket in place and make sure it is seated correctly.

4.) Return and fasten the four screws (previously removed) to secure the battery bracket to the cage

assembly, as indicated in

5.) Return the battery, as described in the

6.) Carefully secure the cables with new cable tie wraps.

7) Return the cabinet cage assembly to the system, reconnect the cables (previously disconnected),

close the cabinet cage door and fasten securely with the two latches.

Refer to the

8) Return the front cover, as described in the

9) Return the left and right side covers, as described in the

Procedure" on page 8-7

10.)Turn ON power to the system.

11.)Proceed to perform the following functionality tests:

Figure 8-148 on page

Figure 8-147 on page

8-6-1-4 "Cabinet Cage Assembly Closing and Installation Procedure" on page

and See "Right Side Cover Installation Procedure" on page 5..

10-6-4 "Grounding Continuity" on page 10-23

10-6-5 "Chassis Current Leakage Test" on page 10-24

Chapter 8 - Replacement Procedures

8-6-3-4 "Battery Bracket Removal Procedure" on page

8-6-2-5 "Battery Installation Procedure" on page

8-2-6-4 "Front Cover Installation Procedure" on page 8-

8-2-3-4 "Left Side Cover Installation

Figure 8-149 on

Show Quick Links