GE Vivid S5 N Service Manual page 274

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
4-2-2 Power ON/Boot-up
NOTE: In the next step, it is necessary to screw the plastic cable clamp (into the hole provided in the
support column - centrally located at the rear of the system, see
Clamp and Securing Screw" on page
Then, to route the Mains Power cable upwards and through the clamp, and secure the clamp
in position to prevent the cable from dangling down and becoming caught in the wheels when
moving the scanner (see
on page
.
6.) Proceed as follows:
a.) Loosen the screw to open the plastic cable clamp.
b.) Route the cable upwards and through the clamp.
c.) Screw the clamp into position on the support column, carefully tightening the screw sufficiently
.
7.) Connect the other end (male plug) of the Mains Power Cable to a hospital-grade mains power outlet
with the proper rated voltage.
8.) Turn ON the circuit breaker at the rear of the system.
The unit is now ready for Power ON/Boot Up.
4-4
2
EVISION
(cont'd)
Figure 4-3 "Mains Power Cable Secured with Plastic Cable Clamp"
4-4).
Figure 4-2 Plastic Cable Clamp and Securing Screw
to secure the cable firmly in the clamp.
Take care not to overtighten the screw, or damage the cable!
Figure 4-3 Mains Power Cable Secured with Plastic Cable Clamp
Section 4-2 - General Procedures
4-4).
VS5 N VS6 N
S
AND
Figure 4-2 "Plastic Cable
Screw hole for Securing Clamp
Plastic Cable Clamp
and Screw
Plastic Cable Clamp
Mains Power Cable
M
ERVICE ANUAL