Figure 35: Connecting An Ac Power Cord Retainer Clip To The Ac Power Cord - Juniper EX3300 Complete Hardware Manual

Complete Hardware Guide for EX3300 Ethernet Switches
106
NOTE: Grounding is required for DC systems and recommended for AC
systems. An AC-powered switch gets additional grounding when you plug
the power supply in the switch into a grounded AC power outlet by using the
AC power cord appropriate for your geographical location.
To connect AC power to the switch:
Squeeze the two sides of the power cord retainer clip and insert the L-shaped ends
1.
of the wire clip into the holes in the bracket on each side of the AC power cord inlet
(Figure 35 on page 106).
The power cord retainer clip extends out of the chassis by 3 in.
Locate the power cord or cords shipped with the switch; the cords have plugs
2.
appropriate for your geographical location. See
EX3300 Switches" on page
WARNING: Ensure that the power cord does not drape where people can
trip on it or block access to switch components.
Insert the coupler end of the power cord into the AC power cord inlet on the rear panel.
3.
Push the power cord into the slot in the adjustment nut of the power cord retainer
4.
clip. Turn the nut until it is tight against the base of the coupler and the slot in the nut
is turned 90° from the top of the switch (see
If the AC power source outlet has a power switch, set it to the OFF (0) position.
5.
Insert the power cord plug into an AC power source outlet.
6.
If the AC power source outlet has a power switch, set it to the ON (|) position.
7.
Figure 35: Connecting an AC Power Cord Retainer Clip to the AC Power
Cord Inlet
Retainer clip
Adjustment nut
"AC Power Cord Specifications for
72.
Figure 36 on page
Copyright © 2015, Juniper Networks, Inc.
107).