Configuring Junos Os On The Ex2200; Ex2200 Switch Default Configuration; Figure 55: Connecting A Fiber-Optic Cable To An Optical Transceiver Installed In - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide

Configuring Junos OS on the EX2200

EX2200 Switch Default Configuration

110
To connect a fiber-optic cable to an optical transceiver installed in a device:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
Figure 55: Connecting a Fiber-Optic Cable to an Optical Transceiver Installed in a Device
Secure the cables so that they do not support their own weight. Place excess cable
4.
out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain
their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.
Do not let fiber-optic cables hang free from the connector. Do not allow
fastened loops of cables to dangle, which stresses the cables at the
fastening point.
EX2200 Switch Default Configuration on page 110
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 114
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 117
Each EX Series switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
Figure 55 on page 110).
Copyright © 2018, Juniper Networks, Inc.