Mounting An Ex9253 Switch On A Rack Or Cabinet - Juniper EX9253 Hardware Manual

To install and connect an EX9253 switch:
1. Follow instructions in
2. Mount the switch by following instructions in
page 78.
3. Connect earth ground to the switch by following instructions in
EX9253 Switch" on page
4. Follow instructions for connecting power as appropriate for your site:
• "Connecting AC Power to an EX9253 Switch and Powering on the Switch" on page 85
• "Connecting DC Power to an EX9253 Switch and Powering on the Switch" on page 87
5. Perform initial configuration of the switch by following instructions in
an EX9253 Switch" on page
6. Set the switch' s management options by following the appropriate instructions:
Connect a Device to a Network for Out-of-Band Management
•
Connect a Device to a Management Console Using an RJ-45 Connector
•
SEE ALSO
Rack and Cabinet Requirements for EX9253 Switches | 54
Clearance Requirements for Airflow and Hardware Maintenance for an EX9253 Switch | 53
Chassis and Component Lifting Guidelines | 205

Mounting an EX9253 Switch on a Rack or Cabinet

Before mounting the switch:
• Verify that the site meets the requirements described in
Switch" on page 48.
• Place the rack in its permanent location, allowing adequate clearance for airflow and maintenance,
and secure it to the building structure.
General Safety Guidelines and Warnings
• Read
Lifting Guidelines
.
• Remove the switch from the shipping carton (see
"Unpacking an EX9253 Switch" on page
82.
104.
, with particular attention to
73.
"Mounting an EX9253 Switch on a Rack or Cabinet" on
"Connecting Earth Ground to an
"Site Preparation Checklist for an EX9253
"Unpacking an EX9253 Switch" on page
"Connecting and Configuring
Chassis and Component
73).
78