Mounting An Ex4200 Switch On Two Posts In A Rack Or Cabinet - Juniper EX4200 Hardware Manual

Figure 30: Attaching Rubber Feet to an EX4200 Switch Chassis

Mounting an EX4200 Switch on Two Posts in a Rack or Cabinet

You can mount an EX4200 switch on two posts of a 19-in. rack (either a two-post or a four-post rack) or
a 19-in. cabinet by using the mounting brackets provided with the switch. (The remainder of this topic
uses "rack" to mean "rack or cabinet.")
You can mount the switch on four posts of a four-post rack by using the mounting brackets provided with
the separately orderable four-post rack-mount kit. See
Rack or Cabinet" on page
NOTE: If you need to mount the switch in a recessed position on either a two-post rack or a
four-post rack, you can use the 2-in.-recess front brackets provided in the separately orderable
four-post rack-mount kit.
Before mounting the switch on two posts in a rack:
Verify that the site meets the requirements described in
on page 58.
Place the rack in its permanent location, allowing adequate clearance for airflow and maintenance, and
secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
Component Lifting Guidelines" on page
Remove the switch from the shipping carton (see
Ensure that you have the following parts and tools available:
120.
271.
"Mounting an EX4200 Switch on Four Posts in a
"Site Preparation Checklist for EX4200 Switches"
264, with particular attention to
"Unpacking an EX4200 Switch" on page
117
"Chassis and
110).