Li - Input Parameters - KEB COMBIVERT F5 Reference Manual

6.2 LI - Input Parameters

LI01
Type of Input
LI02
Digital Input Filter
LI03
Speed Input Decoding
i
Determines whether the digital inputs are PNP (sourcing, +24VDC = ON) or
NPN (sinking, 0VDC = ON). This setting is applied globally to all inputs.
Settings:
PNP
NPN
Default = PNP (0)
This parameter controls a digital noise filter which can be used to mask relay
bounce or other unwanted momentary signals. This filter applies to all digital
inputs except the Drive Enable input (I7). The drive enable input is processed
immediately.
When the Control Type US04 is set as Digital (0) or Binary (1) Speed Selection,
the logic table to which selected speed for a digital input combination must
be determined.
Settings:
B(Level - Correction - Inspection) + D(Level - Correct. - High - Inspect.)
B(Inspection - Level - Correction) + D(Level - Correct. - High - Inspect.)
B(Level - Correction - High) + D(Level - Correct. - High - Inspect.)
Decode with LI16 + D(Level - Correct. - High - Inspect.)
B(Level - Correction - Inspection) + D(Level - Correct. - High - Inspect.)
B(Level - Correction - Inspection) + D(Level - High - Inspect. - Interm.)
B(Level - Correction - Inspection) + D(Inspect. - Level - High - Interm.)
B(Level - Correction - Inspection) + D(Level - Int.2 - High - Inspect.)
Default =
B(Level - Correction - Inspection) + D(Level - Correct. - High - Inspect.)(0)
B indicates US04 Control Type = Binary Speed Selection
D indicates US04 Control Type = Digital Speed Selection
Refer to US04 Control Type = Binary Speed Selection & Digital Speed
Selection for description of the basic operation.
The LI03 setting only changes the logic table according to the
corresponding US04 Control Type setting.
LI - Input Parameters
NUM
0
1
US04 = Binary Speed Selection
US04 = Digital Speed Selection
NUM
0
1
2
3
0
4
8
12
121