KEB COMBIVERT F5 Reference Manual page 127

Programmable
Input Functions for
LI04 - LI11:
Speed Selection**
ETS
(Emergency
Terminal
Slowdown)**
NTS1
(Normal Terminal
Slowdown)**
NTS2
(Normal Terminal
Slowdown)**
NTS3
(Normal Terminal
Slowdown)**
Inspection Speed
Regen Fault
Braking Transistor
On
125% NTS
Default (LI04-11) = No Function (0)
* Can be selected in combination (e.g. UPS + Reduced Torque + Emergency Profile)
** Additional information
LI - Input Parameters
Description of Functionality:
Input assigned for speed selection when US04 =
Binary or Digital Speed Selection; I1 > I2 ... > I8.
Emergency Terminal Slowdown
Normal Terminal Slowdown 1
Normal Terminal Slowdown 2
Normal Terminal Slowdown 3
Signaling the inspection speed input during a run
can be used with serial and analog speed control
types to indicate an inspection run and prevent
from triggering 'Unintended Movement' faults or
'Drive Enable Dropped' events since the controller
may drop all inputs (enable, direction, speed)
and brake at the same time during inspection
runs. During inspection runs, the input must be
held high until the drive returns the Mode = Idle
(nOP) status. In addition, an inspection run limits
maximum speed command to 150 ft/min.
Input triggers 'Regen Fault' error. This is an active
low input function that is triggered by the Ready
Digital Output (X2A.20) of the R6 Regen.
The internal braking transistor can be turned on
by the digital output (X2A.20) of the R6 Regen.
When triggered, the drive will be configured for
125% load NTS tests. This input is active low.
NUM
27
28
29
30
31
32
33
34
35
127