KEB COMBIVERT F5 Reference Manual page 110

Parameters Descriptions
110
Control Setting:
These parameters contain advanced adjustment parameters which
affect the motor gains, system inertia gains, pre-torque, etc.
Timer Parameters:
These parameters adjust brake and drive signaling timers.
Positioning Parameters:
These parameters contain the adjustments needed for the drive
positioning control.
Special Functions:
These parameters allow advanced drive adjustments and facilitate
function tests of drive components.
Analog I/O:
These parameters define and adjust the analog inputs and outputs.
Outputs:
These parameters define the functionality of the relay and solid-state
drive outputs.
Diagnostic Parameters:
These parameters define the functionality of the relay and solid-
state drive outputs and are only viewable in Combivis, although most
should be available in the Diagnostics Screens.
Debug Parameter Group (DB):
Displays the execution time of the timer interrupts that are used to
execute the software's primary functions. This group is only visible
with Combivis.
Field Bus Configuration:
These parameters define the settings for control with serial
communication data.
Terminal Slowdown:
These parameters define the settings for NTSD inputs and speed
thresholds.
Not all parameters may be viewable and changeable, depending on the
i
password accessibility. Refer to Section 4.7.2 for additional informa-
tion on password access.
LC01...LC44
LT01...LT31
LP01...LP23
LX01...LX25
LA01...LA60
LO01...LO32
DG01...DG99 (Combivis only)
DB00...DB02 (Combivis only)
FB01...FB55
TS01...TS08