Manual Programming; Getting Started - KEB COMBIVERT F5 Reference Manual

5.2 Manual
Programming

5.2.1 Getting Started

i
Copy drive to operator (Previously Programmed Drive):
1.
Install the operator keypad, the boot sequence will begin, and the display
will indicate that the settings between the drive and operator do not match
and are not synchronized; press the ENTER button to proceed.
2.
Press the F2 button under "Upld." The display will show "Reading
Configuration from Drive" along with a progress bar.
3.
Once the parameters have been read from the drive, the user will be
instructed to verify the uploaded parameter values and to navigate to Basic
Setup parameter US05. Press the ESC button to continue to the home screen.
4.
At the home screen, the mode window will display "not configured" and the
Ready / Stop / Error LED will be orange. Press the F3 button under "Prog" to
display the programming menu. With the programming menu displayed, press
the down button to navigate to Basic Setup. (If Basic Setup is not visible in
the menu, it will be necessary to enter the OEM password 479 to access the
Basic Setup parameters and finish the download process – see section 4.7.2,
"Setting the Password" on page 73.)
5.
Press the ENTER button to select Basic Setup. Then press the down button
to navigate to US05 Load Configuration – the status will show "0: not configured" .
Press the ENTER button to access US05.
6.
Press the ENTER button again and the keypad will enter edit mode. Press
the up button, search for and select "2: Write Config. To Drive" , then press the
ENTER button. The display will show "Writing Configuration to Drive" along
with a progress bar.
7.
Once the process is complete, the home screen will be displayed. The mode
window will display "idle" and the Ready / Stop / Error light will be green to
indicate that the drive is ready for operation.
This section serves as a quick guide to manually program a KEB Elevator
drive from default. Please note that advanced functionality or settings might
not be listed in this section.
For more information on specific parameters see section 6.0 - Parameter
Descriptions
The KEB drive can be programmed manually. When powering up at default
for the first time, press the F1 button under "Prog" or if already at the home
screen, press the F3 button under "Prog" to access the programming menu.
To manually program the LCD keypad, the user should begin at the
top of the programming menu with "Basic Setup" and work their way
downwards, filling in the required information. The OEM Password level
must be set to make changes.
Initial Start Up
91