Lcd Keypad; Serial/Can Hardware Version; Led Indicators - KEB COMBIVERT F5 Reference Manual

LCD Keypad

4.2 Serial/CAN
Hardware Version

4.2.1 LED Indicators

76
Hardware
Use
Pin
1
2
3
4
5
6
7
8
9
The LED indicators are available only on the Serial LCD Operator. The
LEDs are used to indicate operational status. They can be used for
troubleshooting and diagnostics. In addition, the function of the LED can
be changed with parameters CH10 - 15. Refer to Section 6.12 for additional
information on CH parameters.
Off
(Green)
(Orange)
(Red - Blinking) A limit has been
(Red - Solid)
X6C
5 4 3 2 1
9 8 7 6
X6C
CAN | RS 485
Bus Communications Diagnostics
Signal
CAN V+
CAN L
CAN H
RxD A -, RS485
RxD B +, RS485
CAN GND )
Bus Ground
TxD A -, RS485
TxD B +, RS485
LED 1
No operation (noP)
Drive not enabled
Inverter running the
motor
-
reached: Torque,
Current, or Voltage (not
yet implemented)
X6D
5 4 3 2 1
9 8 7 6
X6D
RS 232/485
Signal
TxD, RS232
RxD, RS232
RxD B +, RS485
RxD A -, RS485
VP +5V (10mA)
Bus Ground
TxD B +, RS485
TxD A -, RS485
LED 2
Run mode
Drive is able to run
Stop mode:
Drive is being
programmed or making
calculations;
FTP file transfer mode.
-
Drive is faulted