Monitor Circuit Wiring Diagrams - KEB COMBIVERT F5 Reference Manual

Brake Transistor Monitor

1.1.5. Monitor Circuit Wiring Diagrams

Brake Transistor Monitor with Elevator Controller Supervision: DC Contactor
F Branch Circuit Fuses
CH Line Choke
EMI EMI Filter
BR Brake Resistor
DC DC Contactor
EC Elevator Control
VC Control Voltage
M Motor
PT Power Terminal
++ for housings E,G,H
+PA for housings R,U,W
22
The DC contactor shall be rated for a minimum of 1000VDC and have a
resistive current rating not less than the maximum braking transistor current
of the connected F5 elevator drive.
The control voltage is typically either 120VAC or 24VDC depending on the
coil voltage of the contactors, I/O on the elevator control, and the ratings of
the temperature sensor on the resistor.
The K1/K2 relay contact in the monitor circuit is rated for pilot duty, 2A at
120VAC or 2A at 24VDC.
The monitor circuit controls a normally closed relay output at terminals K1
and K2 near the power terminal. K1 and K2 are connected to either the
elevator controller or a DC or line contactor as shown in the following wiring
diagrams.
L1
L2
L3
GND
EC
Out DC
In BRT
F CH EMI
GND GND
BR
DC
Com
F5
X1A
L1
L2
L3
GND
+ + +PA PT
- -
PB
GND
T1
T2
VC
GND
u
M v
w
K1 Brake Transistor
Watchdog
K2