Dg - Diagnostics Parameters (Combivis Only) - KEB COMBIVERT F5 Reference Manual

DG - Diagnostics Parameters (Combivis only)

6.16 DG - Diagnostics Parameters
(Combivis only)
The DG diagnostics parameter group is only viewable from the computer
software program Combivis and not from the keypad operator. Most
diagnostics can be found in the Diagnostics Menu from the Home screen.
Refer to section 7.1 for additional information.
In some cases, other parameters can be linked to DG parameters (eg.
Fb13-16 PDO Map Assignments, LO30 Data Value 1 output condition).
The following table lists an overview of the DG parameters. Additional
information on select parameters may be found in the parameter
descriptions following the table.
Para: Name:
DG01* Input Status
DG02* Inverter Status
DG03 Command Speed
DG04 Elevator Position
DG05 Actual Torque
DG06 Motor Current
DG07 Motor Speed
DG08 DC Bus Voltage
DG09 Magnetizing Current
DG10 Modulation Grade
DG11* Output Status
DG16* Output Condition State
DG17 Output Frequency
DG18 Output Voltage
DG19* Parameter Set
DG20 Raw Pattern
DG21 Processed Pattern
DG30 Peak DC Volts
DG31 Peak Current
DG32 Peak Speed
DG33 Raw Pretorque
DG34 Post Pretorque
DG35 Analog Output 1
DG36 Analog Output 2
DG37 Heatsink Temperature
DG38 Motor Temperature
DG39 Carrier Frequency
Unit - Unit -
English: Metric:
rpm rpm
in mm
lb-ft Nm
A A
rpm rpm
VDC VDC
A A
% %
Hz Hz
V V
% %
% %
VDC VDC
A A
ft/min m/s
% %
% %
V V
V V
C C
C C
kHz kHz
Hex:
1181h
1182h
1183h
1184h
1185h
1186h
1187h
1188h
1189h
118Ah
118Bh
1190h
1191h
1192h
1193h
1194h
1195h
119Eh
119Fh
11A0h
11A1h
11A2h
11A3h
11A4h
11A5h
11A6h
11A7h
249