KEB COMBIVERT F5 Reference Manual page 112

US - Basic Setup Parameters
US04
Control Type
112
This parameter selects the type of speed selection and rotation setting. Further
details for each are provided on the following pages.
Setting:
Digital Speed
Selection
Binary Speed
Selection
Absolute
Analog Speed
Bi-polar Analog
Speed
Serial Speed
DIN66019,
Service 49
Serial Speed
DIN66019,
Service 50
Serial Binary
Speed,
DIN66019
Service 50
CiA417
Digital inputs for speed and direction can be programmed to I1...I6, I8
i
with LI04-11, where I1>I2>...I8 for speed inputs
Logic tables for input-selected speed control are determined by LI03
and or with LI16.
LI15 determines whether digital inputs and/or Control Word are used as
direction signal for serial speed control modes.
See sections 3.1 and 3.2 for the appropriate control terminal layout.
See Control Sequence part of this section for signal sequencing.
Description:
Four digital inputs select up to five different
speeds.
Three digital, binary-coded inputs select up to
seven different speeds.
0...10V = 0...Contract Speed
Direction by digital inputs
0...±10V = 0...±Contract Speed
Direction by polarity, digital input for start
Service 49 = 4x16-bit serial communication.
Speed profile and control inputs via serial
communication. Hardware enable required.
Service 50=2x16-bit+1x32-bit+1x32-bit AUX R/W
Speed profile and control inputs via serial
communication. Hardware enable required.
Service 50=2x16-bit+1x32-bit+1x32-bit AUX R/W
The speed selection for Serial Binary Speed is
done through the control-word bits 4, 5, and 6
(Bin. Speed 1 - Bin. Speed 3). Hardware enable
required.
This setting is for using CAN Open Lift
functionality; see CAN Open Lift supplemental
manual 00F5LUZ-KCAN for description and
implementation.
Default = Binary Speed Selection (1)
NUM
0
1
2
3
4
5
6
7