KEB COMBIVERT F5 Reference Manual page 170

LS - Speed Profile Parameters

LS15
High Speed Profile
LS16
One Floor Profile
LS17
Emergency Profile
170
Preset profiles, LS15-LS17
Preset profile settings are available for selection based on type of desired
profile. The presets will automatically adjust the acceleration, deceleration
and jerk rates for a corresponding speed selection. 'Soft' settings will have a
relaxed profile, while 'Hard' settings will have quicker, more aggressive rates.
If changes are made to any of the pre-settings, the option will reflect this by
displaying 'Custom' to indicate changes have been made.
Settings:
Default = Custom (0)
Custom
Soft
Medium
Hard
Profile Mode (High Speed Profile only)
External Profile
Internal Profile
Default = Custom (0)
When US04 Control Type = Bi-polar Analog Speed (3), Absolute Analog
Speed (2), Serial Speed DIN66019 Service 49 (4), Serial Speed DIN66019
Service 50 (5) , the speed profile is generated externally by the controller
and the drive's ramp generator is turned off. It is possible to override the
external profile and utilize the drive's internal profile with LS15 = Internal
Profile; refer to LS15 for additional information. When US04 Control Type
= Binary Speed Selection (1), Digital Speed Selection (0), or Serial Binary
Speed DIN66019 Service 50 (6), only Internal Profile Mode is actually used
and setting for External Profile in LS15 is ignored.
Preset speed profile for High Speed profile.
Additionally, there is the option Internal Profile (4), in which the High Speed
profile settings LS20-25 can be used to limit the rates of externally generated
speed profiles from analog or serial speed control modes. That is, the profile
will be generated by the drive when the rates are less than those dictated by
the controller.
Preset speed profile for One Floor Speed profiles (Intermediate Speeds 1
and 2).
Preset speed profile for Emergency Speed profile (Intermediate Speed 3 or
Emergency Profile input function).
NUM
0
1
2
3
0
4